Instructions for Installing Your Lightscapes Pond Product
Step 1: Remove all contents in the box.
Step 2: Take the flag base and set it on a solid flat surface.
Step 3: With your thumbs together, push down on the outer edge of your solar light firmly. The light will pop up and out of the foam piece. See Photo below.
Step 4: IMPORTANT! Take the light, flip it over and there will be a small switch; turn it on.
Step 5: Reinsert the light back into the foam piece. Repeat with the other two solar lights.
Step 6: Remove the rubber band and unroll the flag. Insert flagpole into plastic holder at center of the floating base. Insert supplied R-clip into the holder hole and through the hole in the pole. NOTE: Certain wind models have multiple R-Clips (at base and connecting the two-part pole). The R-Clips will ensure you do not lose your flag if the station happens to tip over.
Step 7: Take the weighted anchor and tie one end of your nylon line around the handle, encircling the handle twice.
Step 8: Tie a secure knot three times to make sure your weight stays attached. If you don't tie a good knot, you could lose your weight in the water.
For Ponds: Before you tie the other end to the clip, be sure to know the maximum water level of your pond and give an extra foot of line to ensure you have room to tie the line to your clip. See Illustration A. below.
Step 9: Proceed to tie the opposite end of your line to your clip the same way as before. See Illustration B. below.
Step 10: Attach the clip to the mount on the underside of the flag unit. In all cases, it is highly recommended to attach to the outer mounting location. The product will withstand 50+ mph winds before flipping over.
For Pools, Hot Tubs and Low Wind Areas: You can attach the clip to the center mount, so the weight is directly underneath the unit.
IMPORTANT - Using the center-mount clip method, the unit will only withstand winds up to 30mph.
Please feel free to call our Customer Service Department with questions. Phone: 260-701-0345